Werbung
Verfügbare Sprachen
Verfügbare Sprachen
UK
Step by step installation explanation
1.
Mount the lift with minimal 3 8 mm bolts to the ceiling. Make sure that a safety of 50% is encountered,
keeping the maximum load of the lift in mind. Make sure the lift is mounted level. When the lift is not
mounted level, this may result in a disfunctional lift.
Mount the lift free from rotating and moving parts of the lift.
2.
When the lift is mounted properly, make sure the cables on the motor drum are organised neatly.
When the cables are not organised, lower the lift to it's down position and organize the rest of the
cable towards the cable mounting clamps.
3.
Connect the lift according the diagram.
4.
When the lift is being activated, make sure there are no obstacles underneath or near the lift.
Possible obstacles are:
Persons
Stairs
Lift systems
Packaging
False ceiling
5 / 6.
Mount the projector cabling in the lift, free from rotating and moving parts.
7.
Mount the Audipack projector mount on the projector.
8.
Mount the projector together with the mount under the lift with the supplied bolts.
4 x M6x20 with washer
8.8 quality
9.
For finishing the ceiling a cut out must be made suitable for the finishing mask. The cut out can be
used to finish the movable ceiling frame. Refer the diagram for the right cut out dimensions.
10.
Mount the fixed ceiling frame in the ceiling with the supplied clamps.
11.
Place the taken out part in the separate moving frame.
12.
Mount this assembly with the M8 windings to the lift. Make sure the winding does not pass the 15 mm
limit in the lower lift frame.
13.
The lift is ready to be adjusted. Refer position 16 for further details.
14.
When a bigger cut out is needed in the ceiling, this part can be mounted underneath the movable
ceiling frame.
Werbung
