SWR Strawberry Blonde Bedienungsanleitung Seite 10

EXTENSION SPEAKER JACK
Use an unshielded 2-conductor cable (NOT A GUITAR CORD!) to connect an additional speaker cabinet. Use a high quality, heavy
gauge cable of at least 18 gauge (the lower the gauge, the heavier the cable). The impedance of the extension speaker should be 8
ohms or greater. If you wish to connect two additional cabinets be sure their combined load impedance is not less than 8 ohms
(equivalent to two 16 ohm speaker cabinets in parallel).
A/C LINE (MAINS) FUSE
The line fuse can open (blow) due to power surges or high power line transients. This fuse will also open in the unlikely event of an
electronics failure inside your amplifier.
Correct size and rating of the line fuse: 3AG, 2 amp slo-blow for 120V operation. 5mm x 20mm, 1 amp slo-blow for 240V operation.
Do not defeat the purpose of this fuse by using a higher amperage rating. This could void your warranty.
A/C LINE CORD RECEPTACLE
Accepts a standard A/C power cable (supplied with the Strawberry Blonde in the United States), used with almost all current musical,
professional and household electronic devices. If it becomes misplaced, replacements can be found at almost any computer,
electronics, or pro audio store. Please note: the rating for this cable is 3-conductor, 18 gauge, 10 amperes. If replacement is
necessary, or if you wish to buy a longer cable, look for the correct rating on the cable.
CABINET FEATURES AND INFORMATION
SPEAKERS
(1) 10" stamped frame woofer, 100 watts, 8 ohm impedance; (1) high frequency piezo tweeter, 150 watts (4kHz and above), 8 ohms.
Crossover point fixed at 4kHz. Frequency response: 30Hz to 16kHz.
CABINET
Made from a combination of plywood and particle board. Interlocking dado and rabbet joints, glued and nailed. Covered in a
"sandstone" vinyl covering. Metal corners. Comes with our "Texas Bar Proof" powdercoated speaker grill. Front slot port located at
bottom.
10 • STRAWBERRY BLONDE