Requirements For The Place Of Operation; Symbols Used; Electrical Connection; Startup - Beem Fresh-Aroma-Perfect Deluxe V2 Bedienungsanleitung

BEEM - Elements of Lifestyle
Requirements for the place of
operation
For safe and trouble-free operation of the ap-
pliance, the installation location must satisfy
the following requirements:
Place the appliance on a stable, level,
‹
heat resistant surface that is also resistant to
splashing water.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a mat under the feet of the appliance.
Do not place the appliance in a hot, wet
‹
or very humid environment or in the vicinity of
inflammable materials. There must be a gap
of at least 15 cm between the appliance and
any walls, furniture or other objects.
When operating, do not leave any valu-
‹
able objects sensitive to moisture or heat in
the vicinity of the appliance in order to avoid
damage by hot steam and water.
Do not install the appliance under a wall
‹
cabinet.
Never place the appliance or parts of
‹
the appliance in the vicinity of strong heat
sources and hot surfaces (e.g., heating,
oven, grill).
The mains socket must be easily accessi-
‹
ble and allow fast disconnection in the event
of an emergency.
Top prevent the appliance from slipping
‹
away, do not lay tablecloths, cloths or servi-
ettes under the feet of the appliance.
The appliance may not be used or stored
‹
outdoors.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
The mains socket must be protected by at
‹
least a 16 A fuse.
Ensure that the mains cable is undam-
‹
aged and is not laid over sharp edges.
The mains cable must not be pulled
‹
tightly, bent, crushed or knotted or come into
contact with hot surfaces.
The electrical safety of the appliance is
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.

Symbols used

DANGER
This indicates an imminent hazardous situ-
ation, which could lead to severe physical
injury or death.
► Follow these instructions to avoid
danger.
WARNING
This indicates a possible hazardous situ-
ation, which could lead to severe physical
injury or death.
► Follow these instructions to avoid
danger.
ATTENTION
This indicates a potentially hazardous situ-
ation, which could lead to minor injuries or
material damage.
► Follow these instructions to avoid
danger.
NOTE
► A note contains additional information
to simplify the use of the appliance.

Startup

Unpacking

1. Remove the appliance, all accessory
parts and the user manual from the box.
EN 15