Electrical Safety; Machine Information; Technical Specifications - Ferm EBM1004P Bersetzung Der Originalbetriebsanleitung

immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
• Do not carry the appliance by the cable.
• Keep all nuts, bolts and screws tight to be sure
the appliance is in safe working condition.
• Disconnect the appliance from the mains
supply
• whenever you leave the machine;
• before clearing a blockage;
• before checking, cleaning or working on the
appliance;
• if the appliance starts to vibrate abnormally.
• Check the dust bag frequently for wear or
deterioration.
• Replace worn or damaged parts.
• Use only genuine replacement parts and
accessories
• Store the appliance only in a dry place.

Electrical safety

Warning! When using electric tools, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury.
Read all these instructions before attempting to
operate this product and save these instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
The machine is double insulated in
accordance with EN60745; therefore no
earth wire is required.
Replacing cables or plugs
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.
. When using a cable
2

2. MACHINE INFORMATION

Intended use
The blower has been design for blowing &
cleaning applications as well as for light suction
purposes.

Technical specifications

Voltage
Frequency
Power input
No load speed
Max. air speed
Nozzle diameter
Sound pressure (Lpa)
Sound power (Lwa)
Vibration
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60335; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
Description
The numbers in the text refer to the diagrams on
pages 2-3
1. Outlet
2. On/Off Switch
3. Lock-on button
4. Suction port
5. Nozzle
5a. Nozzle extension piece
6. Dust bag
8. Variable speed wheel
220 - 240 V~
50 Hz
600 W
0-13.900/min
4.1 m /s
3
30 mm
82.1 dB(A) k=2.5 dB(A)
95 dB(A) k=2.5 dB(A)
2.994 m/s k=1.5 m/s
2 2
5