Whispbar K671W Fitting Kit Montageanleitung Seite 9

EN
Fitting Kit
K671W
Now cut the rubber insert at the 2 lines you
marked in the earlier instruction. Once cut
you should end up with 4 x 50mm pieces of
the rubber insert.
Note: Be careful of sharp edges after
cutting the rubber insert.
Remove one side of adhesive tape
backing. Apply to underside of rubber
insert as shown. Remove second backing,
then apply downward pressure onto
vehicle.
To reveal the screw thread in the mounting
points, remove the sealant covering them
with a sharp tool.
9