Sub-Zero ICB427 Installationsanweisung Seite 8

M O D E L S I C B 4 2 4
M O D E L S L E V E L
I C B 4 2 4
I C B 4 2 4 F S
Using an adjustable wrench or pliers, turn
each of the four leveling legs clockwise to raise
the unit and counterclockwise to lower the
unit. For the location of the leveling legs, see
illustration 6 below.
For Model ICB424, the countertop bracket
should be used to make a solid installation.
Refer to illustration 2 on page 5. If this is not
possible, wedge shims along the sides and
top.
8
A N D
T H E U N I T
To reduce the possibility of the unit
tipping forward, the front leveling legs
must be in contact with the floor.
I C B 4 2 4 F S I N S TA L L AT I O N
H O M E A L A R M
Before the kickplate is installed, all necessary
wiring connections in the compressor compart-
ment should be completed.
If a home alarm system is to be installed on
the Wine Storage unit, the connections should
be made using the logic supplied with the
alarm specifications. See illustration 7 below
for the appliance lead locations, and refer to
the following for color codes:
Use the 6 mm spade terminals or wire nuts
provided to make the proper wiring connec-
tions.
IMPORTANT NOTE: If you are not responsible
for alarm system connection, this information
should be supplied to the home security
system contractor.
Leveling Legs
Illus. 6
C O N N E C T I O N S
Normally open contacts – white with red
stripe wire
Normally closed contacts – white with blue
stripe wire
Common – gray with white stripe wire
The alarm circuit in the unit is intended as
a low-voltage, low-current device only. It
should not be used to switch line power.
Any unused terminals should be
completely insulated and all wires should
be secured away from conductive or
moving components.
Illus. 7
Home Alarm
Connections