Product Description; Installation Steps - Viega Tempoplex Plus 6960 Bedienungsanleitung

GB Tempoplex Plus Shower Drain Instructions for Use
Proper use
The Tempoplex Plus shower drain is intended for use in flat and superflat shower trays
with a 90 mm waste hole. Only water with a temperature of no more than 95 °C as
commonly encountered in households should be introduced. The introduction of other
liquids is prohibited. No potentially damaging substances such as cleaning agents that
could harm plumbing fixtures, water drainage systems or piping, especially substances
with a pH value ≤ 4, should be introduced.
Installation should be performed by technically qualified personnel in compliance with
local building codes. This shower drain conforms to EN 274.

Product description

Model Art. No.
6960 578 916
6960.1 559 991
A
Components
Cover plate
Gasket
B
Dimensions
C

Installation steps

Prior to installation, check that a drainage rate of 0.85 l/s at a water height of 15 mm is adequate.
Ball joint socket DN 50 is made of PP (cannot be glued).
Place the double gasket on
the sealing surface and press
into the retaining groove.
Tighten the screws evenly.
Do not use a cordless
screwdriver.
D
Special case
For shower tub bottoms
thicker than 10 mm,
cut the seal.
E Access to the drainage system (cleaning)
Make sure that the odour trap is not damaged during the cleaning process.
Remove the immersion pipe.
Insert the sealing plug flush
by hand.
Features
with cover plate, with ball joint drain connection
without cover plate
Insert pipe
Odour trap
Position the body of the drain
with gasket under the shower
tray. Push the upper part
of the double gasket through
the waste hole.
Slide the insert pipe into the
odour trap.
Cut above the lower
gasket lip.
Remove the sealing plug
by turning gently with pliers.
Note the plug position.
12
Mounting flange with screws
Ball joint socket DN 50
Thread in the mounting
screws by hand.
Press the cover plate onto
the three retaining points.
Place the lower part on the
body of the drain, the upper
part into the waste hole.
Clean the drain pipe with an
appropriate cleaning process.
Position the immersion pipe
and mount the cover plate
(see fig. C 6).