Improper Use Of Compressor; Safety Measures - Schneider Airsystems AirMaster AM 22-8 Original Bedienungsanleitung

4 IMPROPER USE OF COMPRESSOR

The manufacturer shall waive all responsibility in case of:
Incorrect use by untrained or negligent personnel.
a
Use in violation of current laws.
b
Incorrect installation.
c
Installation without suitable reservoir.
d
Installation in dust-filled environments (i.e. cement, silica etc.....).
e
Incorrect electrical connection.
f
Serious lack of proper maintenance.
g
Use of non-original spares for the model.
h
Total or partial failure to observe the instructions.
i
Damage due to natural or exceptional events.
j
Tampering with the safety valve.
k
Exceeding maximum pressure rating through tampering.
l
m Operation of compressor without panels and guards.

5 SAFETY MEASURES

Read carefully to avoid potential risks.
DANGER
Handling................................................. Base designed for use with forklift and transpallet forklift.
Electrical Connection ............................. Built-in full load AC23-filled circuit-breaker.
Electrical Board...................................... Bolted on, with door interlock switch.
Emergency............................................. Built- in yellow/red warning light.
Short Circuit ........................................... Built-in line fuses.
Motor Overload ...................................... Magneto-thermal cut-out.
Electrostatic Discharge .......................... De-oiling filter with electrical continuity.
Compressor Overheat ........................... 110 °C thermostat with cut-out.
Insufficient Lubrication ........................... 110 °C thermostat for 'adiabatic' compression.
Starting Under Load............................... 10 sec. delay from energizing
Overpressure ......................................... Approved safety valve.
Back-Pressure ....................................... Non-return valve
Residual Pressure ................................. Descharge tap and internal air gauge.
Phase Reversal
(wrong direction of rotation)
Temperature
Max. Environment > 40° C .................... 110 °C thermostat.
Min Environment < 2° C...................... See starting recommendations.
Pressure Parts ....................................... Built to 2009/105/EG standards.
Flexible Hoses ....................................... High pressure hose used (4-6 times working pressure).
Hot Surfaces .......................................... Parts reaching 70 °C + marked with warnings
MEASURES
Indicator arrow or R.S.F. electronic relay
2-6