Troubleshooting; Compliance - Legamaster XTX-5500UHD Benutzerhandbuch

TROUBLESHOOTING / COMPLIANCE

11. TROUBLESHOOTING

Before calling service personnel, please check the following chart for a possible cause to the trouble you are
experiencing.
• Perform the adjustments according to page 13 -"Operation" and page 21 -"Touch Operation".
• If the problem you have experienced isn't described below or you can't correct the problem, stop using the
display and call service personnel or your dealer.
PROBLEM
No Display
The image is not centered
The image is not locked correctly
The remote control doesn't work
The picture color looks poor
Touch does not function

12. COMPLIANCE

FCC:
FCC CFR Title 47 Part 15 Subpart B Class A, CISPR 22
ANSI C63.4
ICES-003
CE:
EN 55032
EN 55024
EN 61000-3-2
EN 61000-3-3
cTUVus:
UL 60950-1
CAN/CSA-C22.2 No. 60950-1
CB:
IEC 60950-1
31
XTX-5500 – USER MANUAL – ENGLISH
CHECK THESE THINGS
Ensure the power plug is installed correctly on both ends
Check the main power switch is set to "—"
Check that source equipment is operating correctly
Check the input signal is compatible with this display
Check the LED light
Check the input signal is compatible with this display
Check the input signal is compatible with this display
Make sure the batteries fresh and are installed correctly
Ensure the remote is aimed at the IR sensor on the front of the display
Some functions are not available with this display, see page 12
Check the picture settings
Reset the display
Ensure the USB cable is installed correctly on both ends
Power the display off and on to recognize if a new PC is connected