Main Unit; Basic Operation - Sharp HT-SBW260 Handbuch

• The setting method of HDMI-CEC and ARC may diff er depending on
the TV. For details about ARC function, please refer to your TV owner's
manual.
• Only HDMI cables of version 1.4 or higher can support the ARC function.
• While in HDMI/ARC/OPTICAL mode, if there's no sound output from the
unit, you may need to activate PCM signal output on your source device
(eg. TV, DVD or Blu-ray player).
OPTICAL input
• Use the optical cable to connect the optical input of this soundbar to the
optical output of VCD, CD, VCR, DVD player.
TIPS:
• While in HDMI/ARC/OPTICAL mode, if there's no sound output from the
unit, you may need to activate PCM signal output on your source device
(eg. TV, DVD or Blu-ray player).
HDMI OUT (ARC)
LINE IN
A. Use a RCA to 3.5mm audio cable (not included) to connect the TV's
audio output sockets to the LINE IN socket on the unit.
B. Use a 3.5mm to 3.5mm audio cable (not included) to connect the TV's
or external audio device headphone socket to the LINE IN socket on
the unit.
TIP:
When you use the headphone output on the TV set, you will be able to
adjust the volume level directly using the TV remote control.
EU
(ARC)
HDMI OUT
UK
Connect to Power
• Before connecting this device to power, ensure you have completed all
other connections.
• Risk of product damage! Only use the supplied mains adaptor as failure
to do this may result in a safety risk and/or damage to the unit.
• Connect power cord to the power adapter, then connect power adapter
to the DC IN socket of the unit and as last step connect it into a mains
socket.
• Use the other power cord to connect the subwoofer to the mains socket.
Pairing the Wireless Subwoofer with the

Main Unit

Automatic pairing
The subwoofer and soundbar will automatically pair when both units are
plugged into the supply and turned on. No cable is needed for connecting
the two units.
– When the subwoofer is pairing with the main unit, the Pairing Indicator
will fl ash fash.
– When the subwoofer is paired with the main unit, the Pairing Indicator
will light up.
NOTE:
– Do not press the PAIR button on the rear of the subwoofer, except for
manual pairing.
– If the automatic pairing fails, pair the subwoofer with the main unit
manually.
Manual pairing
Press the PAIR button on the rear of the subwoofer.
NOTE:
– If the wireless connection fails again, check if there is confl ict or strong
interference (for example, interference from an electronic device) around
your location. Remove these confl icts or strong interferences and repeat
the above procedures.
– The subwoofer should be within 6m of the soundbar in an open area.
– If a device is connected via HDMI (CEC active), the main unit and the
subwoofer will switch on automatically when the external device is
switched on.

Basic Operation

Standby/ON
• When you fi rst connect the unit to the main socket, the unit will be in
STANDBY mode.
• Press the button on the remote control to switch the main unit ON
or OFF.
~AC IN
DC IN
EN