Sharp HT-SBW260 Handbuch Seite 6

4
A: Normal Placement
(Place Soundbar on leveled surface in front of TV.)
B: Wall Mounting
Wall Mounting
NOTE:
– Installation must be carried out by qualifi ed personnel only. Incorrect
assembly can result in severe personal injury and property damage (if
you intend to install this product yourself, you must check for installa-
tions such as electrical wiring and plumbing that may be buried inside
the wall). It is the installer's responsibility to verify that the wall will safely
support the total load of the unit and wall brackets.
– Additional tools (not included) are required for the installation.
– Do not overtighten screws.
– Keep this instruction manual for future reference.
– Use an electronic stud fi nder to check the wall type before drilling and
mounting.
1
3
5
1. Place the Wall Bracket Installation Guide (included) against the wall
and ensure that it is aligned with center of your TV; the guide must be
in a horizontal position. To make it easier to position, you can stick this
guide to the wall. To ensure that the wall is not marked, use low tack
adhesive.
2. Push a sharp pencil tip through the image of wall bracket screw holes
and mark the correct location for the supporting screws. Once this is
done you can then remove the guide from the wall.
2
4
3. Now drill 6mm diameter holes into the wall at the locations marked in
stage 2 above. Push one wall plug into each hole, ensuring that it is
fi rmly fi xed and not protruding above the hole exit. Now use provided
self-tapping screws to secure the wall brackets.
4. Place the soundbar onto the wall brackets. Ensure that the wall
mounting holes on the bottom of soundbar are aligned with holes on
the wall brackets.
5. Use the metric screws provided to secure soundbar to the wall brackets.
Connections
HDMI input
1. Connect the TV HDMI input and the soundbar HDMI output with the
HDMI cable (not included).
2. Connect the DVD HDMI output and the soundbar HDMI input with the
HDMI cable (not included).
If your TV/DVD supports CEC function, they can control each other based
on the CEC protocol. It is important to ensure that the CEC functionality of
the television is turned on.
HDMI output (ARC)
The ARC (Audio Return Channel) function allows you to send audio
from your ARC- compliant TV to your sound bar through a single HDMI
connection. To enjoy the ARC function, please ensure your TV is both
HDMI-CEC and ARC compliant and set up accordingly. When correctly set
up, you can use your TV remote control to adjust the volume output (VOL
+/- and MUTE) of the sound bar.
– Connect the HDMI cable (not included) from unit's HDMI OUT (ARC)
socket to the HDMI (ARC) socket on your ARC compliant TV. Then press
the remote control to select HDMI ARC.
TIPS:
• Your TV must support the HDMI-CEC and ARC function. HDMI-CEC and
ARC must be set to On.
(ARC)
HDMI OUT
HDMI OUT (ARC)