Peavey PV 5300 Bedienungsanleitung Seite 21

Mic/Line Input
1
2
3
4
7
8A
(1) HIGH (TREBLE) TONE CONTROL
An active tone control (shelving type: ±15 dB) that varies the level
of the high frequency range.
(2) LOW (BASS) TONE CONTROL
An active tone control (shelving type: ±15 dB) that varies the level of
the low frequency range.
Caution: Excessive low frequency boost causes greater power
consumption and increases the possibility of speaker damage.
(3) REVERB CONTROL
This is used as a send control to the effects bus. It controls the
amount of reverberation added to the input signals.
(4) LEVEL CONTROL
The level control for each channel sends the signal to the master
5
mix bus. Typical operation is between 4 and 8 (dependent upon
the input devices) but should be lower than the master level.
Please remember that this acts like a preamp, so if you are using
a device that has a volume output control (i.e., a tape or CD
player) you will need to match the levels by adjusting the level
controls on each unit.
(5) CLIP LED
Indicates when the signal level is within 3 dB of clipping.
6
(6) 3-PIN (XLR) LOW-IMPEDANCE MICROPHONE INPUT
This input is for typical balanced, low-impedance microphones.
It will automatically provide 15V phantom power for condenser
mics or active direct boxes. This has an input impedance of 1k
ohms. The connector is wired as: Pin 1=shield; Pin 2=positive
(hot); Pin 3=negative (cold).
(7) 1/4" LINE
The 1/4" line input connector is used to connect line-level
sources to the channel input. The line input is typically used for
sources like keyboards and CD players and can be used with the
high level output of wireless microphone receivers. When this
input is used, the XLR mic input is disconnected.
(8A) AND (8B) MEDIA INPUT
8B
These inputs, RCA (8A) and 1/8" (8B) accept a stereo input from
the output of an MP3 player, CD player, tape deck or other similar
device.