Philips VARI LITE VLX Wash Luminare Handbuch Seite 32

❋
VARI LITE® - VLX™ W
Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows:
a. Connect one end of cable to luminaire handle.
b. Loop at least once around truss/pipe and attach other end of cable to other handle.
Step 4. Connect power and data cables according to procedure given in
Power" on page
WARNING: DO NOT connect or disconnect energized power cable at fixture (under load). Turn off
circuit breaker (or completely de-energize circuit) before connecting or disconnecting power cable at
fixture. Power is only removed from the fixture by disconnecting power cable from source or turning
off source circuit breaker.
Step 5. Be sure pan and tilt locks are disengaged (refer to
details) to allow full head and yoke movement.
Use enclosure handles for safety cable anchor
points (refer to Top View illustration below).
Top View
Safety Cable (not included)
16
L U '
ASH UMINAIRE SER S
17.
27.4"
(696 mm)
17.5"
(445 mm)
Figure 2-5: Hanging Configuration and Dimensions
07 Au gu st 2009 (Pre limina ry)
M
ANUAL
"Luminaire Overview" on page 6
21.5"
(546 mm)
Safety Cable:
Recommended for all hanging installations and
may be required by local codes.
"Connecting Data and
for
22.0"
(559 mm)
On Center
Head Tilt Lock
02 .9 690.00 01 0