Cisco Linksys PLK200 Installationsanleitung Seite 5

D.
The End User License Agreement
screen will appear. If you agree and
want to begin the installation, click
Next.
E.
The Preparing to Install screen
will appear briefly, followed by a
STOP screen. At this point, connect
one end of an Ethernet network
cable to the Ethernet port of the
Adapter. Connect the other end to
an Ethernet port on the computer
running the Setup Wizard.
Before plugging in the Adapter,
write down the Device Password
printed on the unit.
F.
Plug the Adapter into an electrical
outlet and then click Next.
IMPORTANT:
the Adapter sends data
over the power lines of
your residence, Linksys
recommends that you plug
the Adapter directly into an
electrical outlet. The Adapter
has its own power filter for
protection against surges.
Because
End User License Agreement End User License Agreement
Connect Connect
Plugs directly into outlet Plugs directly into outlet
Connection to a Desktop Computer Connection to a Desktop Computer
Installation
Screen Screen
3