Specifications; Care Instructions - MARIMEX ProStar 3 Anweisungen

With every switching of the 6-way valve the filter
pump must be turned off!
Filter run time (2 x 4 – 5 hours a day) and the regular backwashing
(2 – 3 minutes) at least 1 x per week as well as the floorcleaning are
the basic requirement for maintained swimming pool water!
Repairs on the pump should only be performed by trained and qualified,
professional technicians.

Specifications:

All models:
6-way valve, filter pump TÜV / GS, filter vessel, connection Ø 32/38
mm, base plate
Model
Flow rate:
Connection:
Amount of Sand:
Pool size:
Filter pump:
Floorcleaning (Illustration 8)
Floorcleaning is done in position FILTER (on the valve). The poolfloor vacuum
cleaner has to be connected with the pool-floor vacuum cleaner hose directly to the
skimmer. Until the pool-floor vacuum cleaner is connected and ready for operation,
the filter pump must be switched off.
Important: The pool-floor vacuum cleaner hose must fully be filled with water so
that the pump does not filter air, only then the pump can be switched on. Will air
get into the filter system, the filter pump is to turn off and the vacuum cleaner
must be vented again.
Now move slowly and smoothly (speeding can stir up dirt) with your vacuum
cleaning brush on the bottom of the pool.
For filter systems without prefilter a skimmer with a strainer basket is beneficial!
20
ProStar 3
3,8 m³/h at 0,4 bar working pressure
230 V, max. 200 W
max. 10 kg
max. 19 m³
with prefilter, not self-priming
Problem treatment
Cause of Problems
Sand contaminated with dirt
Pump sucks air
(Bubbles at the inlet)
Skimmer or pump gets too little water
Skimmer basket contaminated
Prefilter basket of the filter pump contaminated
To Winterize the System
At the end of the swimming season, the filter system and the hoses must be
removed and emptied.
This is done when the filter vassel as well as the filter pump by opening the drain
plug. Open the filter vessel and empty the filter sand. Verify that the filter sand is
still in reasonable condition (not glued or clumped) and clean it.
Filter systems located outdoors must be located in a frost-free room in the winter.

Care instructions

Visible contaminants are removed through the filtration system. This is not true
for algae, bacteria and other microorganisms, which are also a constant threat to
clear, clean and healthy pool water. For their prevention or removal, special water
treatment is available, properly and permanently dosed, guarantee for swimmers
any kind of harassment and ensure proper hygienic bath water.
Contact information
www.marimex.cz
+420 261 222 11
e-mail:
info@marimex.cz
Solution
Backwashing (cleaning of the sand)
defective hoses,
tighten hose clamps
Check water level and increase if necessary,
check the intake for dirt accumulation
Cleaning of the skimmer basket
Cleaning oft he prefilter basket
EN
21