Konig Electronic SEC-DVR202S Anleitung Seite 6

Using the Mouse:
Click and hold the left mouse button, drag the mouse to enlarge the area and click to set the video
recording method.
Return to the previous menu to save the parameters.
Alarm:
Press the "Select" button or click the ◄/► icon to set the parameters of each option.
BUZZER DURATION:
Use this option to set the buzzer duration (in seconds)
after which the alarm is activated.
The setting options include 05, 10, 15, 20, 25, 30 (in
seconds), CONT and OFF. Default value is "OFF". When
the "Buzzer Duration" is set to "cont" the buzzer will work
continuously.
EVENT REC DURATION:
Use this option to set the recording duration (in seconds)
after activation by motion detection.
The setting options include 05, 10, 15, 20, 25 and 30 (in
seconds).
MOTION DETECTION:
CHANNEL:
Select the channel (1, 2, 3, 4) for motion-detected
recording mode.
SENSITIVITY:
Use this option to set the sensitivity of the integrated
motion detector for recording. The higher the number, the lower the sensitivity. The setting options
include 1, 2, 3, 4 and Off. The highest sensitivity level is 1.
MOTION AREA:
Use this option to select the motion detection area.
Use the remote control buttons or the mouse to determine the area.
Keypad and mouse control instructions below.
Using the Keypad or the Remote Control:
Press the "Select" button once to select the area, press the "Select" button again to cancel the area.
CH1=Up / CH2=Down / CH3=Left / CH4=Right.
Using the Mouse:
Click and hold the left mouse button, move the mouse to select, deselect or reselect the motion-
detected area for recording.
The area can only be selected from top to bottom and from left to right. When the area is marked blue,
it is activated for recording. When the area is transparent, it does not record.
After completing the motion area setting, press the "MENU" button or right-click to exit.
To start motion record mode, complete the "Motion Area" setup.
6