Hilti SCO 6-A22 Bedienungsanleitung Seite 21

6.1.2.1 Fitting an accessory tool
Risk of damage. The collet can break if tightened when no accessory tool is fitted.
▶ Never tighten the collet when no accessory tool is fitted.
1. Clean the connection end of the accessory tool.
2. Check that the collet has been fitted.
3. Press the spindle lockbutton and hold it in this position.
4. Insert the accessory tool in the collet and tighten the clamping nut with the hex. wrench.
5. Release the spindle lockbutton.
6. Check that the accessory tool is held securely.
6.1.3 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Press the spindle lockbutton and hold it in this position.
2. Use the hex. wrench to release the clamping nut.
◁ The collet is slack.
3. Remove the accessory tool.
6.1.4 Changing the collet
1. Press the spindle lockbutton and hold it in this position.
2. Use a hex. wrench to release and remove the clamping nut.
3. Remove the existing collet and fit the collet you wish to use.
4. Screw on and tighten the clamping nut and then release the spindle lockbutton.
6.1.5 Installing the depth gauge
WARNING
Risk of injury! A damaged depth gauge may present a risk of inadvertent contact with the accessory
tool.
▶ Do not use the power tool if the depth gauge is defective.
1. Hold the depth gauge in position on the product and tighten the securing screw.
2. Slacken the securing screw to adjust the depth gauge.
3. Slide the depth gauge to the desired position and re-tighten the securing screw.
4. Before starting, make sure that the space behind the workpiece is enough to keep the accessory tool
from contacting a hard object.
6.1.6 Installing the vacuum cleaner hose connector
1. Remove the accessory tool. → page 17
2. Install the hose connector on the product and set the connector to the desired position.
3. Engage the retaining lugs.
6.2 Types of work
Warning! Risk of damage!
▶ Operation of the direction of rotation and/or function selector switch while the tool is running may
result in damage to the tool.
▶ Do not operate this switch while the tool is running.
Observe the safety instructions and warnings in this documentation and on the product.
Printed: 30.11.2017 | Doc-Nr: PUB / 5373445 / 000 / 01
4
5
6
7
English 17