Safety Instructions Relating To Operation; Safety Notices And Directions Relating To The Electrical Installation - elero Veco Montageanleitung

Safety
2.7

Safety instructions relating to operation

The operator of the device is obligated to ensure the safe and proper state
❏
of the device before the initial start of operation.
This is also necessary during operation of the device at regular intervals to
❏
be determined by the plant operator.
2.8 Safety notices and directions relating to the electrical instal-
lation
All work on the electrical system must be performed only by authorized
❏
skilled electricians in accordance with the applicable rules and stipulations
of the trade association, in particular the stipulations of DIN VDE 0100.
Furthermore, the national statutory regulations of the respective country of
use must be observed.
In the event of any defects, such as loose connections or defective or dam-
❏
aged cables, the device must not be put into operation.
In the event of faults with the electrical equipment, the device must be
❏
switched off immediately.
The device must be switched off to de-energized before any inspection,
❏
installation or dismantling work.
The device must not be hosed down with a high-pressure cleaner or steam
❏
jet.
The following must be checked before connecting the device to the power sup-
ply:
Are all electrical connections, safety devices, fuses, etc. properly installed,
❏
connected and earthed?
Is the power connection provided in accordance with the specifications in
❏
the electrical circuit diagram (voltage type, voltage level)?
Has the supply line been de-energized?
❏
11