General; Information Relating To The Installation Instructions; Standards And Guidelines; Intended Use - elero Veco Montageanleitung

General

1 General
1.1

Information relating to the installation instructions

The classification of the contents is based on the life stages of the linear drive (here-
inafter referred to as the "device"). The manufacturer reserves the right to make
changes to the technical specifications stated in these installation instructions. In
detail these can differ from the respective version of the device without the factual
information being fundamentally changed and without losing their validity. The cur-
rent status of the technical specifications can be requested from the manufacturer at
any time. Any claims arising from this cannot be asserted. Deviations from the text
and pictorial statements are possible and are dependent on the technical develop-
ment, equipment and accessories of the device. The manufacturer shall provide
information about any differing details relating to special versions by means of the
sales documentation. Other specifications shall remain unaffected by this.
1.2

Standards and guidelines

During construction the fundamental health and safety requirements were ap-
plied and provision was made for the appropriate legislation, standards, direc-
tives and guidelines. The safety element is confirmed by the Declaration of
Incorporation (see section 5 "Declaration of Incorporation"). All information relat-
ing to safety in these installation instructions refers to the laws and regulations
that are currently valid in Germany. All information in these installation instruc-
tions must be complied with at all times and without limitation. In addition to the
safety notices and directions in these installation instructions, the regulations
applicable at the place of installation with regard to accident prevention, envi-
ronmental protection and occupational safety must be observed and adhered to.
The guidelines and standards for safety assessment can be found in the Decla-
ration of Incorporation.
1.3

Intended use

The unit is designed for use in façade construction. It is used for moving small
loads. Other fields of application must be agreed in advance with the manufac-
turer.
The operator alone is liable for any damage arising from the non-intended use
of the device. The manufacturer assumes no liability for personal injury or dam-
age to property caused through misuse or procedural errors, improper operator
control or improper start of operation.
3