auna C-300 Bedienungsanleitung Seite 11

Power supply
• Ultra stable PWM (Pulse width modulated)
• Power supply (10.5-16V)
• Thermal Protection circuit
• Remote on power switchingTransient noise muting
General
• Transient noise muting
• Turn on delay
• Speaker short circuit protection
• Chassis mount ATC fuse protection
CONNECTION OF POWER CORD
• Since this unit deals with a high power, Large current will flow and the
wiring or power cord is high importance.
• Connect the red wire directly to the (+) terminal of the battery using the
cord with a fuse holder supplied.
• Connect the black wire tightly to an appropriate screw on the metal
part of car after removing paint for proper grounding. Be sure to use the
screw.
Connecrtion of remote on/on wire
• Connect the orange wire to a switched power cord of the car stereo to
be connected to this unit will control the unit power on/off with the car
stereo
• The switched power cord may be obtained an auto antenna cord of the
car stereo.
Connection of booster input (high input)
• This unit can be connected to any car stereo with high level outputs,
common or separated ground outputs.
• Separated ground car stereo connection;-connect car stereo speaker
output cables to the high level input connector (+) and (-),right and left
polarity.
• Common ground car stereo connection;-connect car stereo speakers
negative output cable to the high level input connector to the two
signs(-)and the remaining cables to (+) right ang left.
EN
11