How To Use - TaoTronics TT-AH007 Bedienungsanleitung

How to Use

• Power on the humidi er. The unit now is in standby mode and the current
relative humidity (RH) will be shown on the display. You can operate the
humidi er through:
1. ON / OFF: Tap the ON / OFF Button to turn on / off the unit. When
turned on, the display lights up indicating the current mist level and RH
value. Both the tank and base LED will light up.
2. HEATING: Tap the HEATING Button to turn on warm mist and a red
heating icon will appear on the display. Tap again to shut off warm mist.
Note: The humidi er will heat the mist, it will take up to 25 minutes for the
mist to warm up. Warm mist can increase mist output by 50 to 100 mL /
hour, but it uses more power than cool mist.
3. HUMIDITY: Tap the HUMIDITY Button to cycle through the RH level
from 30% to 75%. Once selected, an "A" icon will appear. In this mode,
the unit will automatically adjust the mist output based on the set RH.
When the set RH is 1% - 10%, 11% - 15%, or over 15% higher than the
ambient RH, Level 1, 2, or 3 mist output will be automatically activated
accordingly. Press the MAX / MIN Button to exit humidity setting.
4. TIMER: Press the TIMER button to set an automatic timer between 1
to 12 hours. The TIMER icon and the set time will appear on the display
and after approx. 3 seconds, the display will return to the normal. After
the timer is set, you can tap the TIMER Button once to check the
current setting. Tap and hold the TIMER Button for 1.5 seconds to exit
the timer function.
5. SLEEP: Tap the SLEEP Button to turn on sleep mode. In 15 seconds, all
the LED lights and display will turn off except the "SLEEP" icon. In sleep
mode, when the ambient RH is at 55% - 70%, Level 1 misting will be
activated; when the ambient RH is below 55%, Level 2 misting will be
activated. The unit will stop putting out mist when the ambient RH is
higher than 70% and resume working once it drops to or below 70%. In
sleep mode, all the beep sounds will be disabled except the one for ON
/ OFF Button. You can tap the SLEEP Button once again to exit sleep
mode. In any other mode, tapping and holding the SLEEP Button for 1.5
seconds can turn on and off the tank and base LED light.
6. MAX / MIN: Tap the MAX / MIN Button to manually adjust the
misting and cycle through Level 1, 2, and 3 mist output. The
corresponding level icon will light up.
7. The unit comes with a memory function. When the unit is shut off and
power is still connected, it will return to the previous setting when turned
back on.
8. When water runs low, the unit will stop working and a "NO WATER" icon
will appear on the display. It will resume working once water is added in
the water tank.
9. In any mode, once the ambient RH reaches over 90%, the humidi er will
stop working and resume working once it drops below 85%.
05/06