Product Diagram; Adding Water; How To Use - TaoTronics Hello Benutzerhandbuch

Product Diagram

Nozzle
Handle
Water tank
Water intake
Filter
Power cable
Water sink
Transducer
Base
Floater
Fixer for oater
LED indicator
Switch
Important
• Please leave the humidifier in the room for at least half an hour before use,
especially when the outdoor temperature is below 5°C / 41°F.
• Do not turn on the unit when no water is in the tank, it will cause
serious damage.
• Do not touch the water in the sink or any component of the sink while the
unit is working.

Adding Water

• Remove the water tank from the base.
• Twist to loosen the switch of the filter on the bottom of the water tank and
fill water in the tank. Twist the filter back on.
• Put the tank back on the base.
Note: Do not fill the water tank via the nozzle.

How to Use

• Turn the switch clockwise passed the "ON" position. A tick sound indicates
the humidifier has been turned on. The LED indicator will be green to show
it has started working.
• Keep turning the switch clockwise to increase the evaporation level.
Maximum evaporation is 300mL/h.
• Turn the switch counterclockwise passed the "OFF" position to turn off the
humidifier. The LED indicator will be off to show it has stopped working.
Low Water Protection
When the water level drops below a minimum amount, the LED indicator
will become red. The humidifier stops working and the LED indicator stays
red when the water is fully depleted.
03/04