Screen "Preselection On Period; Screen "Tag Programming; Screen "Authorize/Block Tag; Screen "Unit Of Measure - CEMO CMT10 Bedienungs- Und Wartungshandbuch

3.4.1.3 SCREEN "PRESELECTION ON PERIOD",

MESSAGE "PREPER"
PrEPEr
This function permits to set a
maximum of units that this user TAG can transfer
during a manager defined period. . It is important
to know that the PERIOD is defined by the man-
ager and is the time betwen "CANCEL TOTALS"
procedure.
Press R to enter in this function. Press
the desired maximum quantity is on the display.
fincrements the value while
ments it. Wait 10 seconds to confirm/save the value.

3.4.1.4 SCREEN "TAG PROGRAMMING"

MESSAGE "TAGSET"
tAGSEt
preselection" (preset) and the "period preselection"
(preper) are set for the user TAG key(s) proceed
as follows:
1. Press to enter in this function
2. Press to select the TAG to program
3. Press to confirm
4. Approach the user TAG for programming,
beep sound and display "OK" are confirming the
good programming of the key
5. Repeat the operations above for all keys to be
programmed with same limits.
To program user TAGs with different limits, it will
be, necessary to repeat operations paragraphs
3.4.1.2 and 3.4.1.3 settings the desired limits.
Should a user have no limits, set "preset" and
"preper" to "0" value.
until
edecre-
Once the "transaction

3.4.1.5 SCREEN "AUTHORIZE/BLOCK TAG"

MESSAGGE "LOCHED"
LOCHEd
to block user TAG keys and/or authorize keys pre-
viously blocked. This function can be used when
key have been lost. Proceed as follows.
1 Press to enter in this function
2. Press until the desired user TAG num-
ber is shown on display. Should this user already
blocked display shows "locked" otherwise it shows
a number (total transferred by this TAG during the
current period) if this is an active user.
3. To modify the current condition of this TAG,
press and wait 10 seconds to confirm/save.

3.4.1.6 SCREEN "UNIT OF MEASURE"

MESSAGE "UNIT"
UnIt
has 4 standard units of measure (Litre - US Gallon
- Quarts & Pint) plus one "Custom" unit that can
be configured by the user. To select the unit, do as
follows:
1. Press button to enter in the function,
the unit of measure starts flashing
2. Press to enter in "unit of measure" mode,
the message "Unit" will be displayed
3. Press to confirm
GB
This function permits
The system
11