Print Directly Onto A Cd/Dvd - HP D7500 series Grundhandbuch

4. Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the photo tray; make sure the stack of photo paper fits within the
photo tray and is no higher than the top of the paper-width guide.
5. Lower the photo tray lid.

Print directly onto a CD/DVD

In addition to printing on paper, the HP Photosmart enables you to print directly on the
surface of specially coated CDs and DVDs for print jobs started from a connected
computer. You can design and create a custom label for your CD or DVD using the
software that came with the HP Photosmart. You can then print the label on your printable
CD or DVD media.
TIP: It is recommended that you write your data to the CD or DVD before printing
the label on it.
NOTE:
control panel. You must use the software that came with the HP Photosmart to print
on a CD/DVD. For more information, see the software help.
To print directly onto a CD/DVD
1. Use the software that came with the product to create and print a CD/DVD label.
2. If the product is placed close to a wall, move it at least 7.5 cm (3 inches) away from
the wall.
3. Carefully remove the CD/DVD holder from the storage area below the main input tray.
The HP Photosmart does not support a CD/DVD print job started from the
Print directly onto a CD/DVD 7