Operation; Prior To Charging A Battery; Connecting The Battery; Starting The Charging Process - AEG LP 10.0 Bedienungsanleitung

J   WarnInG!
HaZarD! When charging, bubbles
may form due to the release of gas.
This gas is inflammable and explosive!
J 
Never charge the battery close to an open
fire or at places where sparks may form.
J 
Always ensure sufficient ventilation.
J 
Only connect and disconnect the battery
connecting cables if the charger is not con-
nected to the alternative current wall socket.

operation



Prior to charging a battery


J 
If the battery must be removed from the
vehicle prior to charging, always remove the
grounded connection from the battery first.
Also, ensure that all other consumers in the
vehicle are turned off.
J 
Ensure sufficient ventilation to allow the
distribution of poisonous vapours or gases.
J 
Ensure that the battery poles are clean. If
the battery has a removable ventilation cap,
fill up every battery cell with distilled water
up to the level recommended by the manu-
facturer. Do not overfill the cells.
J 
If the battery has no caps, refer to the
manufacturers recommendations regarding
charging and charging speed.

Connecting the battery


J 
WarnInG!
ELEctrIcaL ScHocK! Always
ensure that the charger is not
connected to the 230 V alternative current
socket when you connect it with a battery.
J
Ensure that the area around the battery is
well ventilated.
j
Connect the positive charging clamp (red) to
the positive pole of the battery (marked
with P or +).
j
Connect the negative charging clamp (black)
ExPLoSIon
j
j
In case of connection with false polarity, the
power supply to the battery is interrupted,
warning acc. to display (see Illustration A).
j 
j 
Battery recognition
The charger now starts to determine the voltage
of the battery. This process may take a few min-
utes. Display during the process shows according
image (see Illustration C).
After the battery size was determined, the display
shows the voltage of the connected battery, 6 V,
12 V, 24 V (see Illustration D). The charging
display shows the charging in process.
charging process
After confirmation of the battery voltage, the
charger starts to charge the battery. The display
HaZarD oF
shows „CH" for several seconds (see Illustration E).
The charger then shows the percentage of
charge (see Illustration E).
Slow charge
When the battery is charged to 90 %, the charg-
er switches to SLOW CHARGE mode with a lower
voltage to fill up the remaining capacity of the
battery.
This is displayed on the operating panel with „SL"
together with the charging status bar lighting
up to the top and bottom (see Illustration F).
Security / Operation
to the negative pole of the battery (marked
with N or -).
Ensure that both charging or pole clamps
have good contact with the corresponding
connecting poles.
Connect the power plug
quate alternative current socket.

Starting the charging process


C onnect the clamps to the battery with the
correct polarity.
C onnect the power plug
quate alternative current socket. Display
shows according image (see Illustration B).
with an ade-
4
with an ade-
4
GB 17