Introduction; Intended Use; Scope Of Delivery; Part Description - AEG LP 10.0 Bedienungsanleitung

Introduction

In this operating manual / this device the following pictogram's are used:
Read operating manual!
Observe warning- and safety
guidelines!
Danger to life and danger of
accident for children!
charger LP 10.0
Introduction

Make yourself familiar with all func-
tions before first start-up of the equip-
ment and gain inform you about correct
handling the device. Read for this the following
operating manual carefully. Store this manual
carefully. Pass on all documents also when
passing on the device to third parties.

Intended use


The charger is intended for charging, float
charging, servicing and the regeneration of 6 V,
12 V and 24 V direct current batteries (only re-
chargeable, maintenance-free, closed batteries
or lead-acid batteries (SLA)), as they are installed
in cars, ships, trucks and other vehicles.
This includes different types of lead-acid
batteries like:
- wet cell batteries/closed lead batteries
(liquid electrolyte)
- gel-batteries (gel-like electrolyte)
- AGM-batteries (electrolyte in fibreglass
fleece)
- maintenance-free batteries and VRLA-bat-
teries (lead-acid-batteries with overpressure
valve)
14 GB
Explosion hazard!
Hazard of electrical schock!
Dispose the packaging
environmentally friendly!
The capacity may range from:
- 6 V 1,2 Ah to 12 Ah
- 12 V 1,2 Ah to 180 Ah
- 24 V 20 Ah to 100 Ah
The charger can be connected directly to the
battery using the clamps.
The charger is not designed to charge other
batteries than those stated above.
It is exclusively certified for the private use. All
other use or change to the device is considered as
not intended and bears substantial dangers. The
manufacturer does not take over any liability for
damages arising from unintended use.

Scope of delivery


After unpacking immediately check the scope of
delivery. Examine the device and all parts for
damages. Do not take a defective device or part
into operation.
1 Charger LP 10.0
1 Instruction manual

Part description


Carrying handle
1
Button GO / STOP (manual start of charging
2
process)
Clamp box
3
Power cable with power plug
4
Display charging status and mode
5