Installation; Before You Do Installation; Hose Connections; Pump Connections For The Original Gardena System - Gardena 7000/D Betriebsanleitung

Before you do installation

WARNING!
• Electric shock!
• Risk of injury due to electric shock.
• Disconnect the product from the mains
before you do installation.

Hose connections

The hose can be connected via the 3 provided
connections (not in scope of delivery):
Connection Connection
nippel (1) 25 nippel (2) 32
mm (1") mm (1¼")
Art. 7193 Art. 7194
1
With GARDENA With GARDENA
Hose Clamp Art. Hose Clamp Art.
7193 7194
Note:
When using a connection with maximum hose diameter,
the pump has the maximum delivery capacity.
Pump connections for the Original
Gardena System
Hose diameter Pump connection
GARDENA Pump Connection Set Art.
13 mm (1/2")
1750

Automatic operation

The float switch (5) turns the pump on automatically when
the water level exceeds the cut-in height and the water is
pumped out. The float switch (5) turns the pump off again
as soon as the water level falls below the cut-out height.
36 - 001 - 08.07.2016

Installation

Hose diameter
16 mm (5/8")
19 mm (3/4")
Note:
The 13 mm (1/2") / 16 mm (3/4")-fittings can also be
Connection-
equipped with a GARDENA Regulator Valve Art. No. 2942
thread (3) 33,3
for 13 mm (1/2")-hose and Art. No 2943 for 16 mm (3/4")-
mm (G1)
hose, so that the contents of the outlet line do not flow
back through the pump after pumping. The Regulator
Valves can be ordered from your GARDENA dealer.

To connect the hose

3
2
2
1
With the Original
GARDENA Sys-
tem
1. Put the connection (1), (2) or (3) with the collar (4) on
2. Tighten the collar (4).
3. Connect the hose with the connection.

Operation

Pump connection
GARDENA Tap Connector Art. 18202
with
GARDENA Hose Connector Art.
18216
GARDENA Pump Connection Set Art.
1752
the outlet of the pump.
4
3
15