Hilti TE 40 Bedienungsanleitung Seite 19

5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.2 Adjusting the depth gauge
1. Press the release button on the side handle.
2. Adjust the depth gauge to the desired drilling depth.
3. Release the release button.
4. Check that the side handle is securely attached.
5.1.3 Removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
To change the chuck, set the function selector switch to this position
1. Disconnect the supply cord plug from the power outlet.
2. Grip over the end of chuck and pull the chuck release collar upwards.
3. Lift the chuck upwards away from the tool.
5.1.4 Fitting the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
Set the function selector switch to the
1. Disconnect the supply cord plug from the power outlet.
2. Grip over the end of the chuck and pull the chuck release collar upwards.
3. Fit the chuck onto the chuck mount.
4. Rotate the chuck until it engages in position.
5.1.5 Fitting / removing the accessory tool
1. Apply a little grease to the connection end of the accessory tool.
◁ Use only genuine Hilti grease. Use of the wrong grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
Printed: 29.05.2017 | Doc-Nr: PUB / 5070954 / 000 / 04
2
3
4
5
"Chiseling" position when changing the chuck.
6
.
English 15