Maintenance - Weelko F336 Bedienungsanleitung

FAQ
Diamond dermabrasion
If the suction effect is reduced:
•
Replace the metal and foam filters.

MAINTENANCE

Micro-crystal dermabrasion
•
The filter in container #1 prevents micro crystals
entering the suction circuit of the equipment. 4
replacement filters are delivered. To replace the filter,
unscrew the cap of the container stand, remove the
old filter, insert the new filter and screw the cap
holder.
•
Clean and disinfect the handle and after each
treatment. It is recommended to dip first ultrasonic
sterilizer and subsequently in an ultraviolet sterilizer.
•
Do not use the appliance if the filter tube attached to
the device is not installed.
•
This filter should be replaced every 5 treatments.
•
To replace the filter:
- Unscrew the top of the tank.
- Remove the filter by pulling and insert the new one.
- Screw the top of the tank, making sure the silicone
gasket is positioned correctly.
Note: Before screwing the top, wipe any traces of
micro crystals in the thread and the silicone gasket to
keep a proper sealing.
4 replacement filters are delivered for their
replacement.
Diamond dermabrasion
•
The foam filter in the handle needs to be changed
after every 5 treatments. Dismantle the handle and
replace the filter. Then reassemble the handle.
•
The metal filter in the handle needs to be changed
after every 5 treatments. Dismantle the handle and
replace the filter. Then reassemble the handle.
•
Clean and sterilize the diamond heads after every
treatment.