Menu For Speed Limit; Error Code - SXT-Scooters Light Plus V eKFV Handbuch

2.3 MENU FOR SPEED LIMIT

MENU for SPEED LIMIT
1. To set up speed limit
• Turn off display
• Press and hold thumb brake
• Power the display
• The display will show "L1"
2. Move to menu with button [LIGHT] L1-L2-L3
• To set up a new speed limit, press button[SET]
Switch kick starter on/off
• Switch on display
• Press and hold thumb brake
• Press the [POWER] button.
• The display shows: P1
• Press set key to switch between off and on
• Release brake

ERROR CODE

E1: Overcurrent protection (Motor does not move
more than 4 seconds)- this error clears after
release the acceleration throttle. If not clear,
send to service.
E2/E4: Communication error (No communication for
more than 400ms) - this error clear when
starting the communication. If not clear, send
to service.
E3: Overvoltage error (Battery voltage higher).
Put back original battery, other hardware
problem.
• Black-Screen. Exposure under the sun for too long.
Place it in shadow and it will return to normal after a
L1= Limit the speed to 6km/h
L2= Limit the speed to 12km/h
L3= Limit the speed to 20km/h
p1 = zero Start [ON/OFF]]
Max. Speedometer = 20 km /h [ON/OFF]
E