Connection Of The Transmitter With An Available Bell System; Connecting A Seperate Bell Button - REV Ritter Arioso Bedienungsanleitung

8. connection of the transmitter with an available bell system

(Only transmitter type 04281R2)
An available bell arrangement can be extended with this radio-controlled gong.
The connection clips B & C (bell connection) must be connected with an approx.
50cm long dual-core wire (bell wire) directly to the connections in the available
bell signal system or gong. The distance between bell and transmitter should be
between approx. 30 to 40cm.
The cable must be lead out of the displayed section of the inner casing.

9. connecting a seperate bell button

(Only for transmitter type 04281R2)
The separate bell button may not be connected with an existing bell system. The
battery must remain in the transmitter.
The connection clips A & B are connected for this purpose with a dual-core wire
system to the bell button. The bell button used must be unlit. Any available fluore-
scent or electric light bulbs must be removed.
18
Transmitter Type 04281R2
Existing bell signal
system / gong
Existing bell
button
Transformer
Transmitter Type 04281R2
C
A
A
B
B
