Battery Operation With With Radio Extension Kit - REV Ritter Arioso Bedienungsanleitung

Please observe that it is recommended to only use bell plates that have no il-
lumination, since the light would lead to the batteries running out very quickly.
These varying connection possibilities enable you to distinguish calls between two
bells, e.g. between for example the bell ring of the entrance door and that of the
apartment door.

7. Battery operation with with radio extension kit

Remove the cover of the gong. Loosen the screws of the wired gong module and
remove it from the module slot. Insert a radio module (with radio extension kit, not
included) and attach it with the existing screws.
Type 04821: Insert 3 x 1.5V batteries into the Gong and 2 x 1.5V AAA batteries
into the transmitter.
Type 04281R2: Insert 3 x 1.5V batteries into the Gong and 1x 3V CR2032 into
the transmitter.
Take care to ensure the polarity is correct.
Match the house code of the gong and the transmitter, i.e. both rotary switches
should point to the same number. This product would not perform normally
under a strong electro static environment, it may need manual reset to normal
operation.
Receiver Transmitter
17