Installing The Panels; Automatic Drive Detection Mode; Drive Type Display - JVC MC-8100LU Bedienungsanleitung

7-5. Installing the panels

CAUTION
s Check the installation screws and cables before installing the panel. Insufficient connections may cause malfunctions.
1.
Attach rear and side panels.
• Screw the panels on, following the procedure in "7-1
Removing the panel" on page E21 in the reverse order.

7-6. Automatic drive detection mode

Note:
After installing, adding, exchanging or removing drives, be sure to execute the auto drive detection mode to prevent any malfunction.
1.
While holding key "8" on the control panel, turn on the
MC-8100LU.

7-7. Drive type display

Check the types of the installed drives as follows.
1.
Press the MODE key while the LCD display is in normal display mode
(to display Menu display).
2.
Press the SELECT key 8 times (to display "9. DRIVE DISPLAY").
3.
Press the ENTER key (to select "9. DRIVE DISPLAY").
4.
The type of the drive in each drive bay will be displayed. (Each press of
the SELECT key displays the information on the next drive.)
Meaning of the display
"DVD-RAM" : DVD-RAM/R drive
"NO DRIVE" : Drive is not connected or installed
● If the automatic drive detection mode has not been executed, the LCD displays "UNKNOWN DRIVE DETECTED".
● If the type displayed for an installed drive is erroneous or if [NO DRIVE] or [UNKNOWN] is displayed, the cable connection to the drive may be
missing or the wrong one. Check the cable connection and drive type again.
2.
Close the door
( a See "5. Door Opening/Closing" on page E17.)
2.
When the LCD display shows "DRIVE DETECTION
COMPLETED", turn off the power of the MC-8100LU.
3.
Turn the MC-8100LU on again.
"ROM/R etc" :Non DVD-RAM/R drive (CD-ROM/R, DVD-ROM, etc.)
"UNKNOWN" : When drive detection mode has not been executed.
Drive Units
9 . D R I V E D I S P L A Y
1 . N O R M A L D I S P L A Y
D R 1 : D V D – R A M
D R 2 : R O M / R e t c
E23