Drive Units; Removing The Panels; Installing The Drive Units - JVC MC-8100LU Bedienungsanleitung

7. DRIVE UNITS

CAUTION
• Make sure that the power is turned off when installing/removing, connecting or setting any drive.
Performing these operations while the power is on will result in the equipment malfunctioning.
Be sure to read the instruction manuals of the drive units before proceeding to any of the following work.
• Note that certain device drivers are incompatible with the simultaneous use of more than one type of drive (mixed use).
Please consult your dealer or nearest JVC service center.

7-1. Removing the panels

1.
Open the door.
( a See "5. Door opening/closing" on page E17.)
2.
Turn off the power.
3.
Remove the rear panel.
• Remove the 6 screws.
• Carefully disconnect the SCSI cable from the
drive.
( a See "7-4. Connecting the cables" on page E22.)
• Unplug both the internal SCSI (SE) cable (50P
cable) and the LVD power cable (6P cable) from
the connectors on the SE-LVD conversion board.
CAUTION
The MC-8100LU main unit and its rear panel are connected by cables. When removing or attaching the rear panel, be
careful not to apply any physical load to the cable connectors.
4.
Remove the side panel.
• Remove the 4 screws.

7-2. Installing the drive units

• When removing the drive units, be sure to disconnect the
control cable and power cable beforehand.
( a See "7-4. Connecting the cables" on page E22.)
1.
Inserting a drive unit.
• Always insert it into a bay with the lowest available
bay No.(from bottom to top)
• Be careful not to snag any cables.
• Be careful not to damage the sensor slit.
2.
Secure the drive unit using the provided metric screws.
• The provided metric screws are attached to the op-
tional drive unit.
CAUTION
Be sure to attach the screws securely. If the library sys-
tem is operated without the screws, either the library or
the drives may be damaged.
Side panel
Rear panel
Sensor slit
* Be careful not
to damage the
sensor slit.
E21