Removing The Optional Carrier Transport Lock Screw; Installing Drives And Settings Scsi-Id No., Etc - JVC MC-8100LU Bedienungsanleitung

Setup

3-3. Removing the optional carrier transport lock screw

When the MC-CF10U is installed, its special transport lock should be removed in addition to its being unlocked as detailed in "3-
1. Opening the transport lock" on page E10. Use the following procedure when unlocking the optional carrier transport lock.
1.
Remove the transport lock screw
(for optional carrier).
2.
Insert the removed screw into
the designated storage hole for
the transport lock screw.
• If the system is transported with the MC-CF10U Optional Carrier installed, refer to "3-1. Opening the transport lock",
execute the packing mode and clamp the above-mentioned transport lock screw.

3-4. Installing drives and settings SCSI-ID No., etc.

1.
Installing drives
Install the drives ( a See "7. DRIVE UNITS" on page E21).
2.
Initial setting of SCSI-ID No., etc.
The default setting of the SCSI-ID No. of the MC-8100LU is "0".
Set the SCSI-ID No. according to your system.
• To change the SCSI-ID No. of the MC-8100LU a Read "8. SETUP OF SCSI ID NUMBER OF THE MAIN UNIT" on
page E24.
• To set the SCSI-ID Nos. of drives a Read the instruction manuals of the installed drives.
• As the MC-8100LU should be turned on to allow its SCSI-ID No. to be set, read "3-5. Connecting the power cord and
cables" on page E13 and connect the power cord before proceeding.
E12