Alarm; Door Alarm; Home Connect; Setting Up Home Connect - Gaggenau RC282 Gebrauchsanleitung

Alarm

en
Alarm
M
D oor alarm
A l a r m
If the appliance door is open for a while, the door alarm
switches on.
Close the door or press T button.
▯
The warning signal is switched off.

Home Connect

o
T his appliance is Wi-Fi-capable and can be remotely
H o m e C o n n e c t
controlled using a mobile device.
Note: Wi-Fi is a registered trademark of the Wi-Fi
Alliance.
In the following cases, the appliance functions like a
refrigerator without a network connection and can still
be manually operated via the controls:
▯
The appliance is not connected to a home network.
▯
Home Connect service is not available in the
country in which the appliance is set up. For an
overview of the countries in which Home Connect is
available, see www.home-connect.com.
Note: Please observe the safety information in this
instruction manual. Ensure that this is also observed if
you operate the appliance via the Home Connect app
and are not at home when doing so.
"Safety instructions" on page 21
~
Follow the instructions in the Home Connect app as
well.
30

Setting up Home Connect

Notes
– Observe the Home Connect supplementary sheet,
which is available for download under
www.gaggenau.com with the instructions. To do so,
enter the E-number of your appliance in the search
field.
– After switching on the appliance, wait at least two
minutes until internal device initialisation is
complete. Only then start setting up Home
Connect.
– To implement settings with Home Connect, the
Home Connect app must be installed on your
mobile device.
Observe the supplied Home Connect documents
for this.
Follow the steps specified by the app to implement
the settings.
– The Home Connect menu will close automatically
when the appliance is not operated for a lengthy
period of time. You can find information on how to
open the Home Connect menu at the start of the
appropriate sections.
Automatic connection with the home network (WLAN)
If a WLAN router with WPS function is available, the
refrigerator can be automatically connected to the home
network.
·
1 Press button.
Temperature display shows Cn.
Press Û button until temperature display
2
shows AC.
3 Press + button.
The appliance is ready for automatic connection.
The temperature display shows an animation for
2 minutes.
The appliance is ready for automatic connection for
as long as the animation is displayed.
4 Within those 2 minutes activate the WPS function
on the home network router (e.g. using WPS/
WLAN button. Observe the information on this
topic in the router documentation).
If connection is successful, On flashes in the
temperature display.
The refrigerator is ready to connect to the app.
Note: If the temperature display shows OF, no
connection could be established.
1 Check whether the refrigerator is located within the
range of the home network (WLAN).
2 Repeat the process or establish the connection
manually.