Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• THIS UNIT IS OPERATED BY 230V/50Hz AC MAINS ONLY. DO NOT CONNECT THE UNIT TO THE MAINS BEFO-
RE CHECKING THE MAINS VOLTAGE AND BEFORE ALL OTHER CONNECTIONS HAVE BEEN MADE.
• WHEN POSITIONING THE UNIT, NEVER COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF
SEVERAL CENTIMETERS AROUND THE UNIT FOR VENTILATION.
1. CONNECT THE POWER CORD (42) TO AN AC OUTLET AND CONNECT THE SPEAKER WIRES TO THE
SPEAKER TERMINAL S (L+R) (39) LOCATED ON THE REAR OF THE UNIT.
2. SWITCH THE POWER ON (9), PRESS THE " AM FM " FUNCTION BUTTON (32). IF THE YELLOW
STATION MARKER LED AND THE RED POWER LED INDICATOR (7) LIGHT UP AND SOUND IS COMING
FROM THE SPEAKERS, THIS INDICATES THE UNIT IS CORRECTLY CONNECTED TO THE POWER.
YOUR SYSTEM IS NOW READY TO PLAY YOUR MUSIC.
MANUAL TUNING
1. SELECT THE DESIRED BAND BY PRESSING THE " AM FM " FUNCTION BUTTON (32) UNTIL THE LCD
DISPLAY (2) SHOWS YOUR DESIRED RADIO BAND (AM OR FM).
2. TUNE TO THE REQUIRED STATION BY TURNING THE TUNING KNOB (23) – THE YELLOW STATION
MARKER LED LIGHT WILL BE ON.
3. ADJUST THE VOLUME KNOB (25) TO THE DESIRED VOLUME LEVEL.
FM & FM-STEREO RECEPTION
• SET THE FM MODE SELECTOR (8) AT " MONO " POSITION. PROGRAMMES ARE RECEIVED IN
MONO MODE. WHEN A STEREO SIGNAL IS PARTICULARLY WEAK, IT IS PREFERABLE TO RECEIVE
THE PROGRAMME IN MONO.
• SWITCH THE FM MODE SELECTOR (8) TO " STEREO " POSITION FOR RECEIVING STEREO PRO-
GRAMMES. THE FM-STEREO LED INDICATOR (21) WILL LIGHT UP TO SHOW AN FM STEREO PRO-
GRAMME IS BEING RECEIVED.
HINTS FOR BEST RECEPTION:
• AM (= MW): THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA. IF "AM" RECEPTION IS WEAK,
SLIGHTLY ROTATING OR REPOSITIONING OF THE UNIT WILL USUALLY IMPROVE "AM" (MEDIUM
WAVE) RECEPTION.
• FM: THE RECEIVER HAS A BUILT-IN FM WIRE ANTENNA (40) HANGING AT THE REAR OF THE CA-
BINET. THIS WIRE SHOULD BE TOTALLY UNRAVELLED AND EXTENDED FOR BEST RECEPTION.
GETTING STARTED
• REMOVE ANY STICKY TAPE AND OTHER PACKING MATERIALS.
• CAREFULLY TURN THE CLEAR PLASTIC PROTECTIVE NEEDLE COVER UP TO EXPOSE THE STYLUS.
TURN DOWN THE STYLUS PROTECTOR AGAIN AFTER EACH USE.
• REMOVE THE BLACK TIE-WRAP AND GENTLY PUSH THE HOLD-DOWN CLIP, WHICH SECURES THE
TONE ARM TO THE ARM REST (37), UP AND TO THE RIGHT.
• ENSURE THAT THE TONE ARM HAS BEEN DETACHED FROM THE TONE ARM REST BEFORE OPERA-
TING AND RE-SECURED AGAIN AFTERWARDS.
• THE UNIT IS NOW READY TO PLAY A RECORD.
Connection
Listening to Radio
Turntable Operation (Phono)
12
Werbung
Inhaltsverzeichnis
