Using Your Wine Cooler - Klarstein Botella 450 Bedienungsanleitung

EN
26

USING YOUR WINE COOLER

Before switching on
• Make sure that it has been installed by a suitably qualified person, as per the
information contained in the installation instructions.
• After delivery, wait for eight hours before connecting the appliance to your mains
supply. This will allow any refrigerant gasses that may have been disturbed during
the transportation process to settle.
• The outside of the appliance and the removable accessories contained within it,
should be cleaned with a solution of liquid detergent and water.
• The interior of the appliance should be cleaned with a solution of sodium
bicarbonate dissolved in lukewarm water.The interior and accessories should be
thoroughly dried, after the cleaning process has been completed.
• There can be an odour when you first switch on the appliance. It will lessen as the
appliance starts to cool.
During first use
• When you use the wine cooler for the first time or restart the appliance after it has
been turned off for
the temperature you select and the one indicated on the LED display. This is normal
and it is due to the length of activation time. Once the wine cooler has been running
for a few hours everything will be back to normal.
• When you first switch on the appliance, the compressor will run continuously until
the wine cooler reaches a cool enough temperature.
• During this period of time, you should try not to open the door frequently or place
bottles inside of the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before
restarting the appliance or reconnecting it to your mains supply.
a long time, there could be a few degrees variance between