Technical Data - Beper 50.000 Betriebsanleitung

Steam station Use instructions
Release the steam button when steam is no longer necessary.
If you want to get continue steam you can press and block the button of continuous steam (12).
This appliance is able to generate steam in vertical position and can be used to iron easily fabrics with steam jet.
If the steam jet becomes lower when ironing, that means the tank is empty.
Attention : Never allow the steam to come out while the iron is placed on the base (7).
Attention : the steam station is always under pressure !
HOW TO FILL THE TANK WHEN USING THE STEAM STATION:
If water will finish while you are still ironing and want to carry on, please operate as follows :
- Turn off the boiler (4). Select desired temperature "MIN" turning the temperature thermostat knob (9).
- Release the pressure from the steam station, keeping the steam button (10) with the finger pressure until steam
stop. Then turn off the iron (5).
- Unplug the cord supply from the socket.
- Wait for the iron and station cool .
- Unscrew safety cap and wait for some minutes.
- Fill the tank with water using the filler funnel.
- Close and tighten the safety cap.
- Press the switches button (4 -5 ).
- Wait for the steam ready pilot lamp (6) lights before carry on ironing.
-The Steam Station is equipped with the safety cap, which prevents the children open the generator tank.
ATTENTION ! Do never try to open the safety cap when the steam station is under pressure.
Do never unscrew the safety cap when the appliance is plugged to the socket.
When used for the first time a little smoke may appear ; that does not last and will stop quickly.
If the iron is not used for a long period (some weeks), it is recommended to press steam button (10) for about 30
seconds, the iron in horizontal position, to clean the intern tubes with steam, before starting ironing.
It is not necessary completely fill the tank for a brief ironing.
NOTE: during initial operation of the iron, a few drops of water mixed with steam may come out of the
soleplate until the temperature stabilizes. It is advisable to direct the first jets of steam onto an old cloth
until a uniform stable jet of steam is obtained.
The iron must always be in movement on the cloth.
N.B. pay attention to the symbol
CLEANING :
Unplug the supply cord.
To clean the body of the appliance, simply use a moist cloth. Do not use solvents or detergents which may harm
the body material.
Do not use metal brushes.
HOW TO STOCK YOUR STEAM STATION:
Switch off the appliance, turn the thermostat knob on "MIN" and unplug the supply cord.
Let the iron cool down on the iron rest. Stock the steam station and pay attention that the supply cord does not
touch the hot parts.
Always stock the steam station on a stable surface and keep it away from children.

TECHNICAL DATA :

Full power : 2000W
Iron power : 800W
Steam station power : 1200W
Power supply : 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
: the cloth or fabric must not be ironed.
9
EN