NGS Roller Glow Bedienungsanleitung Seite 4

CHARGING THE BLUETOOTH
SPEAKER
1. Connect the Bluetooth speaker's micro USB socket with
the computer's USB port through USB cable.
2. The charging LED will turn ON in red light; the
rechargeable battery is in charging.
3. The charging LED red light will turn OFF when the
rechargeable battery is fully charged.
4. Disconnect the USB cable, and close the rubber seal
cover when it is done.
BLUETOOTH SPEAKER PAIRING /
RECONNECTING
1. Turn on the power, a message sound; "beep" will
announce from speaker and the mode LED will blinking
in blue; the device is turned ON and goes into searching /
paring / reconnect mode for pair.
2. Now, turn ON the Bluetooth function on your mobile
phone.
3. Search for "NGS ROLLER GLOW" and select it to pair (for
first time pairing or pairing a new mobile device).
4. The Bluetooth speaker will be reconnecting
automatically if your mobile phone has been
paired (Depend on the of mobile phone's type and
configuration, manual reconnection may require on
some devices).
5. If pairing is successful, a message sound; "beep" will
announce from speaker and the mode LED light will
keep turn on.