Check Battery Status - Raikko EVOLUTION Bluetooth Bedienungsanleitung

English
You cannot pair more than one terminal/playback device at the
same time. Only one terminal/audio playback device can access
the EVOLUTION BT at a time. If there is an existing Bluetooth
®
connection, you can also make phone calls via the EVOLUTION BT
provided that the paired device (terminal/audio playback device)
supports this function.
AUDIo oUtPUt VIA CABLe ConneCtIon
In order to playback an audio signal via a cable connection,
plug the line IN cable supplied into the corresponding port (8).
Connect the other end to the headphone jack on your smartphone,
mobile, MP3/4 player or to the audio output on a computer/laptop
(terminal/audioplayback equipment). The Bluetooth
automatically interrupted when a cable is inserted. This is shown by
a red light on the status LED. Playback via Bluetooth
(if available) when the cable is removed. The LED display is blue again.
When using external audio mode, short press start-stop-button (4) for
mute mode.
sUPPLYInG PoWeR to eXteRnAL DeVICes
The EVOLUTION BT is equipped with a USB port (6) which can be
®
used to supply power to electronic devices that can be charged via
USB (smartphones, mobiles, MP3/4 players, navigation devices).
Use the appropriate cable/connector combinations from the adapter
kit supplied to connect the devices you wish to charge to the
EVOLUTION BT . To act as a power supply, the EVOLUTION BT
®
needs to be switched on.
18
®
EVOLUTION Bluetooth English
Caution! Only use devices which conform to the USB standard (5 V)
®
,
®
CHARGInG tHe eVoLUtIon Bt
Connect the EVOLUTION BT
the charging cable supplied in order to charge the device. Connect
one end to the charging port (Micro-USB) (5) on the EVOLUTION BT
and the other end to the corresponding USB port. You can also charge
® connection is the device on a power socket by connecting it to the USB network
adapter supplied. Green LEDs on the battery display (7) show that
is restarted the device is charging by moving from left to right. The current charge
®
status is shown by the number of solidly lit LEDs. If all of the LEDs are
continuously lit, this shows that the battery is fully charged.
This may take up to 12 hours, depending on the status of the
EVOLUTION BT

CHeCK BAtteRY stAtUs

To check the battery status, press the power switch (1) on the
EVOLUTION BT
on. The remaining charge is shown by the number of lights that are
still on.
®
for this connection. Devices with different technical
specifications may be damaged if connected.
The battery life of the speaker system will be shorter if
energy is being supplied to external devices.
®
to a USB port on a PC or a laptop using
®
battery and the source used to charge it.
®
once briefly when the device is already switched
®
®
EVOLUTION Bluetooth
®
19