Elektror 2SD series Betriebs- Und Montageanleitung Seite 16

Operating and assembly instructions 1SD, 2SD
8 DECLARATION OF INCORPORATION ACCORDING TO APPENDIX II 1 B
DECLARATION OF CONFORMITY IN ACC. WITH EVPG (ENERGY CONSUMPTION
RELEVANT PRODUCTS ACT).SECTION 4 PARAGRAPH 1
EN
The manufacturer,
Elektror airsystems gmbh
Hellmuth-Hirth-Str. 2
D-73760 Ostfi ldern
hereby declares that the product to which this declaration refers meets the basic requirements of the Machinery Directive
(2006/42/EC) as set forth below.
Description of incomplete machine:
Single stage side channel blower:
Double stage side channel blower:
Double fl ow side channel blower:
Serial number and year of manufacture can be found on the nameplate and on the accompanying delivery slip.
Description of the essential requirements of Machinery Directive (2006/42/EC), with which the partially completed machine
complies:
Machinery Directive (2006/42/EC): Annex I, Articles 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.5.1, 1.6.1, 1.7.1, 1.7.3
Electromagnetic Compatibility Directive (2014/30/EU)
Eco-design Directive for Energy-related Products (2009/125/EC)
The partially completed machine described here continues to fulfi l the protective regulations of the Low Voltage Directive
(2014/35/EC) according to Annex I, No. 1.5.1 of the Machinery Directive.
The commissioning of the partially completed machine is not permitted until it has been verifi ed that the machine in which the
partially completed machine is to be installed, complies with the provisions of the Machinery Directive (2006/42/EC).
The following harmonised standards were applied:
DIN EN ISO 12100 2011
DIN EN 60034-1
DIN EN 60034-5
DIN EN 60034-30-1 2014
DIN EN 60204-1
16
DIN EN 60664-1
The manufacturer, Elektror airsystems gmbh, undertakes to make the special documentation on this incomplete machine available,
electronically or in hardcopy, to national authorities on demand.
The special technical documentation belonging to this incomplete machine was prepared in accordance with Annex VII Part B.
Mr Kevin Kargar, tel. +49 711 31973-1179, is responsible for the documentation.
Kreher (Managing Director)
Ostfi ldern, 30.06.2019
1SD 210, 1SE 210, 1SD 310, 1SD 410, 1SE 410, 1SD 510, 1SD 510 FU/FUK,
1SD 710, 1SD 810, 1SD 910
2SD 220, 2SD 320, 2SD 420, 2SD 520, 2SD 720, 2SD 820, 2SD 920
2SD 740, 2SD 840
Safety of machinery, general principles for design,
risk assessment and risk minimisation
2011 Rotating electrical machines, Part 1: Rating and performance
2007 Rotating electrical machines, Part 5: Degrees of protection provided
by the integral design of rotating electrical machines (IP code) – Classifi cation
Rotating electrical machines - Part 30: Effi ciency classes of single-speed, three-phase,
cage-induction motors (IE code)
2007 Safety of machinery – Electrical equipment of machines,
Part 1: General requirements
2008 Insulation coordination for equipment within low-voltage systems,
Part 1: Principles, requirements and tests
www.elektror.com