Important Safety Instructions - Fluval 07 Serie Benutzerhandbuch

IMPORTANT SAFETY INSTRUCTIONS

WARNING - To guard against injury, basic safety precautions should be observed including the following:
READ & FOLLOW ALL
1.
SAFETY INSTRUCTIONS
and all the important notices on the appliance before using. Failure
to do so may result in the loss of fish life and/or damage to the
appliance.
DANGER
– To avoid possible electric shock, special care should be
2.
taken since water is employed in the use of aquarium equipment.
For each of the following situations, do not attempt repairs
yourself, return the appliance to an authorized service facility for
service or discard the appliance.
A. If the appliance falls into the water, DON'T reach for it! First
unplug it and then retrieve it. If electrical components of the
appliance get wet, unplug the appliance immediately.
B. If the appliance shows any sign of abnormal water leakage or if
RCD (or GFCI – Ground Fault Current Interrupter) switches off,
disconnect the power supply cord from the mains.
C. Carefully examine the appliance after installation. It should not
be plugged in if there is water on parts not intended to be wet.
D. Do not operate any appliance if it has a damaged cord or plug,
or if it is malfunctioning or it is dropped or damaged in any
manner. The power cord of this appliance cannot be replaced. If
the cord is damaged, the appliance should be discarded. Never
cut the cord.
E. To avoid the possibility of the appliance plug or receptacle
getting wet, position the appliance to one side of a wall mounted
receptacle. To prevent water from dripping onto the receptacle
or plug, a "drip loop" (see picture) should be arranged by the
user in the cord connecting appliance to a receptacle. The "drip
loop" is that part of the cord below the level of the receptacle
or the connector, to prevent
water travelling along the cord
and coming in contact with
the receptacle. If the plug or
receptacle does get wet, DON'T
unplug the cord. Disconnect
the fuse or circuit breaker that
supplies power to the appliance. Then unplug and examine for
presence of water in receptacle.
WARNING – Close supervision is necessary
3.
when any appliance is used by or near children.
This appliance can be used by children ages 8
years and above and persons with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
To avoid injury, do not touch moving parts or hot parts.
4.
CAUTION
– Always unplug or disconnect all appliances in the
5.
aquarium from electricity supply before placing hands in water,
before putting on or taking off parts and while the equipment is
being installed, maintained or handled. Grasp the plug and pull
to disconnect. Never yank cord to pull plug from outlet. Always
unplug an appliance from an outlet when not in use.
This is an AQUARIUM FILTER-PUMP INTENDED FOR DOMESTIC and
6.
INDOOR use only. It is intended for use in ornamental household
aquariums. It may be used with fresh or salt water. Maximum
water temperature 35°C. Do not use this appliance for other than
intended use (ie: DO NOT use in swimming pools, bathrooms etc.).
The use of attachments not recommended or sold by the appliance
manufacturer may cause an unsafe condition and will invalidate
your warranty.
This appliance is not a submersible aquarium filter pump. Do not
7.
install or store this appliance where it will be exposed to the weather
or temperatures below freezing.
Make sure that this appliance is securely installed before operating it
8.
and that the electrical connection is in accordance with the data on
the rating label. Do not allow filter pump to run dry.
If an extension cord is necessary, a cord with proper rating should
9.
be used. A cord rated for less amperes or watts than the appliance
rating may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled. The connection should be
carried out by a qualified electrical installer.
SAVE THESE INSTRUCTIONS
10.
for future reference.
EN-2