Installation; Safety Precautions; Local Setup; Wall Mounting - Triax GHV 12 -85 serie Bedienungsanleitung

GHV 1200-85/204 House Distribution Amplifier /
Hausanschlussverstärker
DOCSIS 3.1

2. Installation

2.1 Safety precautions

BEWARE:
You must adhere to the Safety Precautions of EN 60728-11 for installation
Before you start working on the installation, turn off Mains Power to the circuit.

Only let an authorized Electrician do the Mains power plug installation if needed.

Never do Installation or repair during thunder Storms.

Always connect the network by use of the Grounding Terminal of the device (with a copper wire

(diameter min. 4 mm2) to the Building Grounding Terminal!
Before you start working on the installation, turn off Mains Power to the circuit!

Observe the safety precautions!

2.2 Local setup

Mount the Amplifier.
Horizontal, free on the wall and so that the convection cooling of the unit

is not constrained.
On non-flammable material (Concrete or Brick Wall)

In a dust free environment, protected against moisture and fluid.

(Drop– and spray water)
Not in a spot with direct Sun radiation (e.g.. On the Roof)

Not directly along with Heat Sources (e.g. Heating Room)

In compliance with the highest allowed working Temperature

(measured at the Airflow under the Amplifier))

2.3 Wall mounting

Fasten the Amplifier according to its measurements (See Fig. 1.) on the wall.

(Screws-ø max. 4.8 mm, Distance between holes 158 mm)
Create a Grounding potential using the screw A and a sufficient fitted and stable copper cable

(diameter min. 4 mm2)
Connect the RF-Input B and the RF-Output C. Make sure you get perfect

connection between Coax cable and Connector.
Turn on the Mains Power to the circuit again.

Fig. 1
mounting
3 EN/DE