Kenwood NEXEDGE NX-230EX Bedienungsanleitung Seite 20

SELECTING A ZONE AND CHANNEL/GROUP ID
Select the desired zone using the key programmed as [Zone
Up] / [Zone Down]. Each zone contains a group of channels.
Select the desired channel/group ID using the Selector knob
(default). Each channel/group ID is programmed with settings
for transmitting and receiving.
• You can toggle the display between the zone and channel/group
ID names and number by pressing the key programmed as Display
Format, or by accessing the Menu {Page12}.
Note: If the default settings for
have been changed, use the appropriate keys to select the zone and
channel/group ID.
TRANSMITTING
1 Select the desired zone and channel/group ID.
2 Press the key programmed as [Monitor] or [Squelch Off ] to
check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone.
Release the PTT switch to receive.
• For best sound quality, hold the transceiver approximately
1.5 inches (3 ~ 4 cm) from your mouth.
■ Making Group Calls (Digital)
If a key has been programmed with [Group], [Group +
SDM], or [Group + Status], you can select a group ID from
the list to make a call to those parties on a Conventional
channel.
To select a group ID:
1 Press the key programmed as [Group], [Group + SDM],
or [Group + Status].
2 Press
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
10
/ to select a group ID/name from the list.
/ and the Selector knob