Unpacking; Assembly - Hecht 8616 SE Originalbetriebsanleitung

• Vibration risk (resulting in vascular and neurological harm in the hand-arm system, for example
so called "white finger disease")
• Dangers caused by contact with harmful liquids, gas, mist, smoke and dust or by their inhalation,
relate to emissions (for example breathing in).
• Danger of fire or explosion relate to spilling of fuel.
• Dangers caused by failing in ergonomic principles by construction of the machine, for example
dangers caused by unhealthy position of body or excessive overcharge and unnature to the
anatomy of the human hand-arm, relate to construction of handle, equilibrium of the machine
and using of toothrest.
• Dangers caused by unexpected starting, unexpected exceeding of engine revs caused by defect/
failure of control system, relate to the defects by the handle and placing of drivers.
• Dangers caused by impossibility to stop the machine in best conditions, relate to solidity of the
handle and placing of engine shut down device.
• Dangers caused by defect of machine control system, relate to solidity of the handle, placing
of drivers and marking.
• Dangers caused by tearing (of the chain) during running.
• Dangers caused by shooting up of subjects or splashing of liquids.

UNPACKING

• Carefully remove the product from the box.
• Carefully inspect all parts. If any part is damaged or missing, contact your dealer or authorized
service center.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger.
• Disposal must be made in accordance with the regulations in force in the country in which the
equipment was installed.
• Make sure that bags and containers of plastic material are left strewn freely in the environment
because they pollute it.
• If you have any doubt do not use the machine, but have it checked by an authorized service
center.
PACKAGE.CONTENTS:
machine, upper handle bar, swing handle, mounting hardware for handle bar, manual for use

ASSEMBLY

1. Take the sweeper out of package and fit the upper handle first using the supplied binder
screws (fig. 2A).
2. Mount the lower part of the handle to the machine body (fig. 3A). Attach the upper handle
using wing nuts (fig. 4A).
3. Connect the cable to the drive control handle (fig. 5A).
4. Now attach the supporting wheels (fig. 6) to the protective sheet to sweeping roller (use
screws / nuts).
5. Now install the guide bar (fig. 7A).
made for garden
EN
DE
CS
SK
PL
25 / 152