AEG HK654206IB Benutzerinformation Seite 17

Cable cross section
230V~
N
L
One-phase connection - 230 V~
N
L
8.4 Attaching the seal to the
rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
stripes. The stripes must have the
same length as the rabbets.
3. Cut the ends of the stripes at an
angle of 45°. They should fit in the
corners of the rabbets accurately.
8.5 Assembly
min.
500mm
Green - yellow
Blue and blue
Black and brown
min.
50mm
min.
2mm
400V 2~N
Two-phase connection - 400 V 2 ~ N
Green - yellow
Blue and blue
Black
Brown
4. Attach the stripes to the rabbets. Do
not extend the stripes. Do not bond
ends of stripes one over another.
After you assemble the hob, seal the
remaining gap between glass ceramic
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
ENGLISH 17
N
L1
L2
N
L1
L2