Herth+Buss 95980775 Bedienhinweis Seite 27

Operating Instruction
10. "HOLD" Button
Press this button momentrily to freeze the
present reading, the meter stays in Data
Hold mode, and " " appears as an indicator.
Press again to exit Data Hold mode, " " dis-
appears. Press and hold down the button for
about 2 seconds to turn on or off the back-
light.
11. Hz/% button.
It can be used to switch the meter between
frequency and duty cycle measurements
when the rotary switch is in Hz Duty position.
12. "REL " Button
It is used for relative measurement.
27
Built­in Buzzer
1. When you press a button, the built-in
buzzer will give a beep if this press is ef-
fective.
2. In continuity test, when the resistance
is less than about 50 Ω, the buzzer will
sound.
95980775
EN