Teesa AROMA F50 Bedienungsanleitung Seite 14

14
4. Place the lid on the milk container so that the arrows on the
lid face towards the handle.
5. Insert the plug of the power cord into a wall socket.
6. Place the milk container on the base.
7. Press the multifunction button:
• once for the hot frothing function- the indicator lights
red and blue
• twice for the cold frothing function- the indicator lights
blue
• three times for the heating function (without frothing)-
the indicator lights red
8. It takes less than 5 minutes to froth/heat milk to a temperature
of approx. 65°C. When the operation is completed, the
appliance switches off automatically.
9. Remove the lid. Grab the appliance by the heat-resistant
handle, lift it off the base and pour out milk. To prevent
the frothing whisk from falling off the bottom of the milk
container, do not tilt the milk container too much when
pouring out milk to a cup.
CAUTION! Danger of scalding! Hold the milk container only by
its handle. Do not touch any other part as it may be hot.
10. After a heating cycle, the appliance needs to cool down for
a few minutes before another use. Rinse the inside of the
container with cold water to let it cool down faster. After a
cold-frothing cycle a new one may start immediately.
11. To turn off the appliance press the multifunction button:
• three times if hot frothing function was used
• twice if cold frothing function was used
EN
• once if heating function was used.
12. Unplug the appliance from power mains, clean and store
it according to the instructions listed in the Cleaning and
Storage section below.
• Prior to cleaning, make sure the appliance is unplugged
from power mains and that it has cooled down completely.
• The milk container, attachment and lid should be cleaned
after each use.
• Cleaning is easiest if you rinse the container, attachment
and lid with warm water immediately after use.
• The milk container may be washed in the dishwasher.
CLEANING
Owner's manual