Preparation For Use; Operation - Teesa AROMA F50 Bedienungsanleitung

Owner's manual
1. After removing the appliance from the packaging, check the
main body, power cord and the attachments for any signs
of damage. In the event of such damage being found, the
appliance must no longer be used. It has to be returned to
the authorized service point for repair.
2. Clean the milk container and the attachments to remove
any production residue as described in the Cleaning section.
IMPORTANT The inside of the milk container and the
contact area between the milk container and the base must
be clean and dry.
3. Make sure to place the appliance on a dry, flat and stable
surface, away from water and heat sources.
Notes:
• It is recommended to use full-fat milk with 3,2% fat content
for frothing.
• It is recommended to use cold milk (for best results, the milk
should be taken from the refrigerator immediately before
frothing).
• Frothed milk increases its volume. The maximum quantity
of milk which can be frothed is about 120 ml (see the
MAX marking inside the milk container).
1. Remove the lid from the milk container.
2. Attach the frothing whisk to the spindle on the bottom of
the milk container and make sure it can rotate freely (do not
fit the attachment when using heating function).
3. Dependently on the function, fill the milk container with
cold milk up to the:
• MAX
marking as the milk may overflow and damage the appliance.
• MAX level (120 ml) to froth milk. Always add sufficient
amount of milk to the milk container- at least up to the
MAX marking.
Not complying with the above may lead to milk overflow and

PREPARATION FOR USE

OPERATION

level (240 ml) to heat milk. Do not exceed MAX
damage to the appliance.
13
EN